EX20S Compact Expandable Cabin 6m

No. This model ships as a finished open room with no factory bathroom, which is what separates it from the fitted units in the range. You can add wet areas two ways. Order a flat packed wet room module that ships inside the same container and bolts in on site, or have a licensed local plumber fit one out after delivery. A kitchen wall can ship with the unit as well.

Both long walls fold outward on a hydraulic assist hinge. A crane lifts the roof and walls into position while four trades secure and seal the joints, and the unit is usually open in under three hours. The pad has to be ready before the truck arrives, either a concrete slab, footings or screw piles set out to the closed footprint of 6,000 x 2,400 mm.

Yes. The mechanism is built for repeat fold and unfold cycles, so the cabin can be closed, craned onto a truck and moved to another block. Allow the same crane and four trades for the refold as for the original deployment, and have your licensed electrician and plumber disconnect services properly before the walls come back in.

In almost all cases yes. Any habitable building in Australia needs approval from your council or a private certifier, and the requirements differ by state, by zoning and by whether the unit is a secondary dwelling, a studio or a temporary site building. We supply drawings, specifications and compliance documentation to support your application. We cannot guarantee that any council or certifier will approve a particular block.

Build time is usually around 20-30 working days from a confirmed order and deposit, then around 20-30 transit days of sea freight to the main Australian ports, including customs clearance and road transport to your block. Adding a wet room module or a kitchen wall to the same order does not normally change the build window. We confirm dates in writing with your quotation.

The cabin arrives folded on a truck at 6,000 x 2,400 x 2,600 mm, so you need a clear run for a semi trailer and standing room for a crane close enough to swing the unit onto the prepared pad. Overhead power lines, tight driveways and soft ground are the three issues that hold deliveries up most often, so send photos of the access before we book transport.

The unit arrives with the electrical rough in and switchboard fitted. A licensed Australian electrician connects the switchboard to your mains supply, generator or solar system, and a licensed plumber connects water and waste once the wet areas are in place. Those connections are always carried out by local licensed trades, never by the delivery crew, and you keep the certificates.

Factory quote available. Every unit is quoted for the layout, fit out and destination you nominate, because the finish, the wet area option and the freight leg all change the number. Send through your block address, intended use and preferred layout and we will send a written quotation covering the unit, delivery to your nearest port and, if you want it, road transport and craneage.